![]() ![]() My external HDD is doing some noise when connected to the PS3 and its annoying. If I can have problems using an HUB then imagine using two to be able to use a lot of devices. However, let me remind you, the bus speed this chip runs at does not cause any issues. Do we always need to connect the USB drives to the PS3 Slims right USB port or just when installing CFW for the first time. Now I know some of you who have dealt with AGND and DGND will tell me that I'm putting digital interference onto the analog ground plane. (The problem child) this *should be connected back directly from the 15 pin connector to its own* ground, but I was unable to solder a wire from the 15pin directly, so I soldered pin 2 to pin 1. Format the USB flash drive in FAT32 system: connect the USB flash drive and right-click on its icon in Windows Explorer Create a folder GAMES on the flash. Pin 12 and Pin 13, the -+USB data need to be connected to lower contact of the resistors directly above the 15 pin clip. There are two types of headsets that can be used on the PS3. Pin8 is another analog ground, this one needs to be connect to the GND side of one of the surface mount diodes to the right of the SST39VF010 chip. OK, so not alot of people know how to do this, so i thought id share this with you. ![]() This also takes care of Pin3,Pin10,Pin11,and Pin14 Pin4-pin7 are all vcc ,5 volt input, and can be connected to at a solder point directly to the left of the smaller "B" symbol next to the large 4716b diode(red wire). ![]() Pin1 and pin15, analog ground, can be wired directly off of the 15pin connector, they have large contact points and are on top and bottom. Even taking a picture of the locations I used, seemed difficult. Unless your a god, or have some REALLY nice soldering equipment, you won't be able to solder directly off of the 15 pin connector, so we will have to find alternatives.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |